Other work on the design of the house. Tools and materials Floors and coatings. Working with tiles.

Proper installation of doors in closets. If after a few years you look closely at the cabinet doors, which previously seemed to be hung perfectly, you will see that they are a bit lopsided. Several movements screwdriver - and all will be OK again. Hinges, which hold the cabinet doors are usually three ways to adjust: the door can be moved in height, horizontally (the Palm), and in some cases, you can still change the force with which the spring presses the door. All are covered with a screwdriver. Doors are set when the cupboard is hung, which means there is no need to remove them beforehand. The fastening system consists of two parts: the hinge which is mounted on the door and a mounting plate located at the door of the cabinet. in the bedroom Standard door cupboards hold on two hinges, only if the door is very large, there may be more. Joints may be different, but in principle they all look alike. Under its own weight door usually tries to bend sideways, away from the hinge, in the bedroom so it is usually quite simple to readjust focus door. Most hinges set screw located slightly left of center pivot, in some cases, this screw closed metal plate that is bent screwdriver. If you want to change the power-pressing the door to the closet to do it start from the top, turning the screw a little to the right, while the gap between the housing and the door of the cabinet - the so-called fit doors - becomes smaller. Then screw the lower ball joint is rotated slightly to the left, and the gap widens (enough to turn the screw half a turn). When installing follow the slit width on the left and right of the door. When the door at the top and bottom are equally distant from the cabinet frame, which means that the installation is correct vedena derivatives. To check, try again to turn the screws: the direction is wrong door position in the bedroom change for the worse. If the door fell down heavily, you may need to raise it a few. On standard hinged height adjustment is performed in place to attach the mounting plate. Plate is attached to the cabinet door with two screws vertically they can move a bit, so releasing both of these screws, you can raise the door. To properly set the height, unscrew the screws on both mounting plates. It should be noted that for some hinges unscrew the mounting in the bedroom plate is not necessary: in the so-called stop there eccentric rotation which changes the vertical displacement of the door and its clamp. If the top or bottom of the door behind the cabinet too, need to change the corresponding distance. The desired screw joint located on the rear of the wall. Please note only: the same standard mounting in the bedroom screw is fixed to the mounting plate. If slightly loosening the screws on both hinges in the bedroom (unscrewing them to the end is not necessary), the door can be given the desired position. All door and pushed forward jumps from a fixed position. To put it in place, push the door back up and fasten the screws so that the distance from it to the cabinet top and bottom match. Hinged with screw-click system only changes the height position. For some systems, first disassemble the door - hinges press down the back, and they bounce off the mounting plate. When remounting the hinge is mounted on the mounting plate and gently press down so he sat down.
Border in the bedroom for wallpaper.
Other work on the design of the house. Tools and materials Floors and coatings. Working with tiles. Electrical operation. Appliances. Kitchen. Plumbing. Wall. Wallpaper Design and Decoration. in the bedroom Furniture repair. Safety in the bedroom in the home. Lighting. in the bedroom Outbuildings